| ADS cranks down the power on StrongARM |
Jan. 26, 2001
[Note: in response to this story, Compaq sent LinuxDevices.com a letter to the editor summarizing the history and accomplishments of Compaq's sleep mode support for the StrongARM processor.]
Applied Data Systems (ADS) will demonstrate what is being described as the first "full sleep mode" support for Embedded Linux on Intel's StrongARM SA-1110 processor at LinuxWorld Expo in New York next week. ADS CEO Robert Olsen claims that "previous power management solutions for the SA-1110 were interim steps toward this more complete, 'full sleep mode' support." The hardware platform being used in the demonstration is ADS' Graphics Master Plus StrongARM-based single board computer (SBC).
The new support, which reduces the SA-1110's power drain from half a watt (full on) to less than ten milliwatts, is of major potential significance to battery operated systems and handheld devices. One important beneficiary of the new power management support is likely to be the handhelds.org project, which has developed an Embedded Linux implementation for Compaq's iPAQ PDA. Additionally, the SA-1110 lies at the basis of numerous other Linux-based mobile or deeply embedded projects -- environments where enhanced power management is always a plus.
"Idle" vs. "sleep"
ADS says previous power management schemes for Linux on StrongARM have been limited to the "on", "off", and "idle" states. According to ADS, the idle and sleep power management modes differ from each other as follows . . .- Idle mode -- a non-operational state initiated by the kernel due to a lack of system activity, where the CPU is running at a slower rate. Peripherals are typically unaffected. The system continues to process interrupts.
- Sleep mode -- all system peripherals are powered off. Only the system's SDRAM memory, the processor's internal real time clock, and certain of the processor's I/O inputs remain powered on. This state is initiated by a call to a sleep function by the application or by an inactivity timeout. Device drivers are notified of transition to this state by a call to their respective power management functions.
In both of these modes, the kernel remains resident in RAM and can "wake up" in a timely fashion without having to be reloaded and uncompressed from non-volatile memory. However, the two modes have greatly differing power requirements due to the fact that nearly all subsystems are powered down in sleep mode but remain on (though idle) in idle mode.
Actual power comparisons
ADS has characterized the new sleep mode support on its Graphics Client Plus SBC, with the following results . . .- Full on -- the board consumed 2W of power, of which 0.5W was attributed to the StrongARM SA-1110
- Sleep mode -- the entire board, including the StrongARM processor, required less than 10 milliwatts (0.01W) total power.
ADS will make the new StrongARM sleep mode support available to the Open Source community as soon as it is fully tested and has been incorporated into the company's SBC Embedded Linux support software, which is expected to occur by March, 2001.
Related stories:
(Click here for further information)
|
|
|
7 Advantages of D2D Backup
For decades, tape has been the backup medium of choice. But, now, disk-to-disk (D2D) backup is gaining in favor. Learn why you should make the move in this whitepaper.
4 Legal Reasons to Control Internet Access
The Internet is obviously a valuable resource for many organizations. However, many are exposed to legal liability concerns because they fail to control Internet access. Learn if you're safe in this white paper.
Rapidly Resolve J2EE Application Problems
Whether you are in the process of building J2EE applications or have J2EE applications already running in production, you must ensure that they deliver the expected ROI. Learn how in this white paper.
Load Testing 2.0 for Web 2.0
There are many unknowns in stress testing Web 2.0 applications. Find out how to test the performance of Web 2.0 in this white paper.
Build Better Games Online
For the game infrastructure providers, life is complex. Making money from games has become more complicated. Why? Find out in this white paper.
Building a Virtual Infrastructure from Servers to Storage
This white paper discusses the virtual storage solutions that reduce cost, increase storage utilization, and address the challenges of backing up and restoring Server environments.
Gaining Faster Wireless Connections with WiMAX
Welcome to what is quickly becoming the hyperconnected world where anything that would benefit from being connected to the network will be connected. Learn more in this white paper.
Is Your Desktop a Security Threat?
The new wave of sophisticated crimeware not only targets specific companies, but also targets desktops and laptops as backdoor entryways into those business’ operations and resources. Learn how to stay safe in this white paper.
Increasing SAN Reliability by 100 Percent
Storage area networks (SAN) are a strong part of storage plans. Learn how to increase your reliability and uptime by 100 percent in this case study.
|
|
|
|
|
news feed